To better use the whirlpool pump, we should learn some methods about the use and maintenance of the whirlpool air pump. Our company is a company specializing in the supply of whirlpool, with professional researchers and strong strength. Here are the methods to share the use and maintenance of the vortex pump with you.
1. vortex air pump should be placed in a more stable place. The surrounding environment should be clean, dry and ventilated.
2. the rotation direction of the impeller of the vortex air pump must be the same as that of the arrow marked on the fan housing.
3. when the vortex air pump works, the working pressure should not be greater than 8KPa, so as not to cause too much heat and excessive current of the air pump to cause damage to the air pump.
4. vortex air pump strictly prohibits solid, liquid and corrosive gases from entering the pump body.
5. the filter screen and silencer at both ends of the inlet and outlet of the vortex air pump should be cleaned timely according to the situation so as not to clog up and affect the use.
6. the connection between the inlet and outlet of the vortex air pump must be connected with hose (for example, rubber tube and plastic spring tube).
7. the replacement of the bearing of the whirlpool pump: the replacement of the bearing must be operated by the person familiar with the repair work. First unscrew the screw on the cover of the pump and disassemble the parts one by one in the graphic order. The dismantled parts should be cleaned and assembled in reverse order. When dismantling, the impeller can not be pried hard, the special Rama is used, and the cushion is not omitted, and the cushion is not omitted. So as not to affect the good clearance of the regulator at the time of the factory.
The 8. vortex pump has no direct contact friction except the two bearings of the motor rotor. The bearing installation method of this gas pump is mainly divided into two types. The first type of air pump end bearing is installed in the pump body of the motor engine seat and the middle of the impeller. The type of air pump is not required to add grease. The bearing of the second type air pump ends is installed in the middle of the pump cover. The bearings of the air pump end should be lubricated regularly. Once a month, the number of gas pumps should be increased for the three class of continuous working air pumps. The maintenance of the bearings at the fan end of this type of air pump motor is based on the first type of air pump.
The above is the knowledge of the whirlpool pump we share with you, hoping to help you better use the whirlpool pump. At the same time, if there is some need, welcome to contact us, we will serve you wholeheartedly, let us work together to create a better tomorrow!